Deutsch DT 2-Pin Splitter Wire (one)

1. The Features section says this is a 14awg harness but the Specifications says it’s 16awg. Which is correct?
   These splitters will utilize 16AWG, and can safely power up to 20 amps worth of auxiliary lighting.
   
   
2. This will allow me to run two pods off of one 9006 plug and use my factory fog light switch correct? I want to replace factory fogs with two pods each side.
   We recommend only running one set of pods off the factory fog light wiring in order to prevent too much power draw on that circuit.
   
   
3. Could I say, use 4 of these on the same power connection, to have 5 different Bluetooth controllers for multi zone control. For a grille light setup and a quad zone control underglow, to be able to individually light up each area? So I wouldn't have to wire in a new power connection and a new power switch.
   You can absolutely install your 5 controllers in this way. The controllers shouldn't need more power than these splitters are capable of supplying so you can piggyback these splitters for your controllers if you wish.
   
   
4. I already have a stealth lightbar installed and fully wired. Can I use this splitter to add two SS3 ditch lights onto the same circuit?
   If you are running our heavy duty wiring harness (which our stealth light bar kit has included with it), you can certainly use a splitter to run some additional pods off the same harness without any issue.
   
   
5. Can use the Splitter to connect two SS3 Led Fog lights Max
   We would recommend only using the splitter for Sport and Pro models, as the Max will be pulling much more power.

Installation Time: 5-10 minutes

Tools Needed: None

Modification: None